THANKS Banner instructions!

We had a great time at the two workshops making this banner! Now that they are done I can share the instructions with you all! There are a few fun techniques that I used in the making of this banner… There are crumpled flowers, box pleat paper ribbon,(better known to the workshop attendees as the “little skirt”) Emerging color, and two-toned custom made patterned cardstock! I of course learned all of these from The Stamp Goddess! If you would like to have this in a printable format leave me a comment or send me your email address and I will send it to you!

I am looking forward to getting my craft on again soon! I love workshops but they put the breaks on my creative time. : /  

So incase you haven’t seen the banner here it is in all it’s glory!

THANKS Banner Instructions

Cutting

Cut 3 of the following

· Sorbet CS 3 ½ X 3 ½ - ink edges with Barn red or chocolate

· Chocolate CS 3 ½ X 3 ½ - Round the corners of this paper then distress edges

· Olivia paper variety 2 ½ X 2 ½ inch squares (flower )

Cut 2 of the following

· Reddish Olivia paper 3 ¼ X 3 ¼ - ink edges with chocolate or barn red then stitch around the paper about ¼ inch from the edge place a brad in each stitched corner on both pieces.

· Green Olivia paper 3 ¼ X 3 ¼ - round the corners then ink with chocolate

· Colonial White CS 3 ¼ x3 ¼ See special instructions below.

Cut 1 of the following

· Orange/yellow Olivia paper 1 X 12 (paper ribbon)ink edges with desired color

· Sorbet CS 2 ½ X 2 ½ inch square(Flower) – cut scalloped circle with Cuttlebug

· Chocolate CS 2 ½ X 2 ½ inch square (Flower) – cut scalloped circle with Cuttlebug

Stamping On Colonial White CS

One (1) tree in chocolate ink from Grown with love and rough cut it out then use a permanent glue stick and completely cover the back of the tree and adhere it to a piece of Chocolate cardstock then cut out. This saves you from cutting it out twice.

Several multi colored leaves from timeless… cut out

1 two tone sunflower from Something Splendid. Base color is a yellow and top color should be chocolate, cut it out.

On 1 of the 3 ¼ X 3 ¼ piece of card stock random stamp a variety of leaves from Timeless. First in Versa mark then the color then onto the paper… scrub and repeat with different leaves and different colors. Then add clear embossing powder and set. After it has cooled for a minute you will use a sponge with Barn Red ink and rub all over the cardstock! You just made your own custom cardstock! Isn’t it cool! Now Stitch around the perimeter and add brads.

On the other piece of 3 ¼ x 3 ¼ CW CS Random stamp flourishes from Cherished flourishes in Olive ink, then sponge or brayer with olive ink.

Assembly

[T] Glue 1 red Olivia paper centered on 1 sorbet paper. Tie Hemp around the stem of the T and add foam tape to T and attach. Then Select 2 felt leaves and attach using liquid glass. Attach the whole thing on to one of the Clear pages of the album…

[H] Sponge one chipboard page with garden green re-inker until desired coverage is reached. Glue one (1) green Olivia paper to one (1) chocolate CS Tie hemp to H and add foam tape. Arrange the H and the tree with the leaves falling into a pile on the Green Olivia paper and attach it all on the Green chipboard page.

[A] Attach the custom made leaf cardstock to one (1) piece of the sorbet CS. Tie Hemp to the A add foam tape and attach to the leaf CS. Tie more hemp onto 3 buttons and cluster next to the A with glue dots

[N] Sponge one chipboard page with garden green re-inker until desired coverage is reached. Attach the custom made Green flourish CS to 1 piece of the Chocolate CS. Tie Hemp to the N add foam tape and place on the Green flourish CS. Spritz all your scalloped circles with the mister, then wad them up. Un-wad them and stack them and fluff them up, poke a hole in the center of the flower and add the filigree charm. Then use the heat gun to dry your flower before attaching it to the Green flourish CS. Take the ¾ X 12 inch strip of orange/yellow paper and box pleat it to make the ribbon. Attach a piece of Chocolate ribbon along the edge of the paper ribbon. Attach the ribbons to the bottom of the finished piece before you add it to the Chipboard page. Add the N and the flower.

[K] Same as T

[S] Same as H. add a button with hemp to the center of the sunflower before adding to the finished page.

[Display] Either string the whole thing on a long piece of Jute and hang it up or you can attach the jump rings and make a table top standing piece!

Supplies

Everyone
Supplies	Item number
Olivia Level 2 paper pack	X7128B
Mix and Mingle mini album	Z1334

To Share
Supplies	Item number	Needed per person
Heartfelt Wonder die cuts	Z1210	2 green and 2 brown
Filigree Charms (set of 8)	Z1269	1
Basic Craft buttons	Z1206	5
Chocolate ribbon	CON063	6 inches
Chocolate cardstock	X5643	1 sheet
Sorbet cardstock	X5751	1 sheet
Pewter Brads (100)	Bulk153	12
Hemp	Z280	For knots on letters and buttons

Tools to complete project

Inks	Stamp sets	Other supplies
· Olive · Barn red · Chocolate · Sunset · Sunny Yellow · Garden Green	· Something splendid. Aug 10 SOTM · Cherished flourishes · Grown with love · timeless... Olivia WOTG	· sponges · Cricut and story book cartridge.. Cut at 2.5 on shadow · Clear embossing powered · Heat gun · Sewing machine · Corner rounder · Brayer · jute.. I have some to share. · Cuttlebug · Nesties Scalloped circle · Piercing tool · Liquid Glass · Glue dots

A busy busy week….

Ok, so I know I was supposed to post another tutorial today but… well it was one crazy busy week! Yesterday we had 3 soccer  games, a trip to the Corn Maize (yes it is spelled maize) and a trip to Nana and Papa’s! That pretty much sums up the week. With two kids in soccer, evening classes and extra hours at work, I just didn’t get my craft on this week. I did have my monthly club meeting were we made the THANKS banner, it was a huge hit and I am working on a reverse side for winter! If I ever get it done I will post pictures for you all!

So today was a lovely Oregon fall day. Rain and wind and laundry and grocery shopping… I did get inspired to make these Salted Carmel Brownies!

So I apologize for the lack of a tutorial this week. I will try for one next week but with 3 soccer games again next weekend and Halloween I am not sure what I will get done!

For your drooling pleasure here is a peek at what I did do today!

Just so that you know I only ate one… and maybe a half… I am taking the rest to work with me tomorrow. I swear… Have a great week!

Pencil box re-do.

So I was looking for pencils in the workroom at school when I saw this almost empty box! Oh how my mind began to race thinking of all the wonderful uses for this very cute little box! So I took the last of the pencils out and brought this little baby home with me. I could hardly believe my luck! I had this great box and 3 days off from work! WOO HOO! So of course I had to make this my next Tutorial! It looks long but it took me less than an hour to figure this little guy out. I hope you can get your hands on one of these boxes too!

From this…

To this!

First thing you are going to need is an OfficeMax pencil box. It comes with 96 pencils in it. I found this one at the kids’ school. Then found out that my Mom’s work also uses these boxes! SO I have two!

Cocoa Card Stock:

• 1 - 10” x 8½” , 1 - 8½” x 5”

White Card Stock.

• 2 3/8” x 11”

Mistletoe Red snowflake paper:

• Front – 7 5/8” x 2 5/8”
• Back – 8” x 2¾”
• Ends – 4” x 2 5/8” -  cut two
• Front flap – 8” x 1 ½”

Mistletoe light green with trees paper:

• Top – 8” x 5”

Mistletoe striped paper:

• Inside bottom - 7½” x 4”

Xacto knife

Bone folder

Scor-Tape

Chocolate ink

Sponge

First you need to open up the box.

Take out the bottom thingy…Sorry I can’t think of what it is called.

Gently pull the box off the outer wrapper. It should come off pretty easily.

Now you have all the parts separated.

Here is another view.

Mark the front of your box. It is the one with the little magnet on it.

Take the outer part of the box and turn it over. You will now be working on the bottom of the box.

Add Scor-Tape around the perimeter of the bottom of the box.The bottom is the part with the barcode.

Remove the outer paper on the Scor-Tape

Line up the 8½ x 5” piece of Cocoa Card stock on the bottom of the box. you will have about an inch on both ends of the bottom.

I like to use my brayer to press the paper down nice and tight.

Run the brayer off the edges to show the edges of the box on the paper. This will help you when it is time to fold the paper over.

Turn it over.

Fold the Cardstock at the edges of the box bottom. so you can see the fold lines.

To make the mitered corner you will cut the corner off here. Don’t cut all the way to the corner of the box. You want a little space there. You will see why later… I made a boo boo… Do this to both corners.

This is what it should look like. Now add Scor-Tape as shown.

Fold over the CS and seal it down. Do both ends first then the long side.

This is a good corner…

This is not… See my boo boo…: ( bummer. Oh well, it happens. Just pull up the edges here and put another little piece of CS there. Then ink the edges with the sponge.. No one will notice.

Ok Now it is nice and covered.

Attach the Scor-Tape all around the inside of the box wrap. Make sure you add some around the window too.

Now take the 10” x 8½” piece of CS and line it up leaving about and inch of over hang on each end just like you did on the bottom. Remember you are working on the opposite side as the bottom.  I didn’t get a picture of me laying it on… sorry… Here you will score the folds you can use the straight edge or your bone folder to do this.

Turn the wrap over and you will see that the CS is on the inside of the box wrap. Miter the edges again. Don’t make the same mistake I did on the bottom.

I used the bone folder here to fold the edges over. It makes nice crisp lines.

Turn it over and press your finger all around the window. This will give you a guide line for cutting it out.

Use your Xacto knife to carefully cut out the cardstock covering the window. Don’t press too hard.

Sand the edges and then ink them to give them a finished look.

Now ink up the edges of the red papers.

Line up your end pieces first.

Wrap the ends around the Front of the box.

See the wrapped ends around the front

Attach the 7 5/8” x 2 5/8” piece  to the front.

Now that you have the red paper on the front and the two ends you will turn it over so you are looking at the bottom. Put Scor-Tape around the perimeter of the bottom of the box.

The box will sit on the bottom of the wrap. I should have taken a picture of the wrap laying there so you could see, sorry. You will attach it to the small part that is not covered with the cocoa cardstock.

Line the box up and press. Rub the inside flaps on the box to make sure you have it stuck down good.

 

Now for the top. Take your 5X8 piece of paper for the top.

Turn the paper over. Now using a ruler and a pencil. Mark the paper at 4”

 

and 7¼. Then 1½” on the top and 1 1/8” from the bottom. Your window opening will be 2 ¾” tall.

Then cut out the window with your Xacto knife.

Turn it over and ink up your edges.

When you attach your top, make sure you line up the window and the ends. There will be some over hang on both of the long sides, this will give the front and back a finished look when you add those pieces...

Attach the 8 x 2¾ red piece to the back.

and the 8 X 1½ red piece to the front flap..

Put the striped paper in the bottom of the box.

If you want to divide the box you can by making this simple divider.

Take a white piece of card stock 2 3/8” x 11”.

Score at 3 ½ from one end and 4” from the other. Then place inside the box.

See now you have 2 little compartments.

Now attach your Velcro Dot. I would put it on the lid first. Here I put it on the box first and it was too high. The lid didn’t close nicely. So when you do your box, take your dot, remove the paper from the rough side and put it on the lid flap where you want it.  Then remove the paper backing from the soft side while it is attached to the rough side. and simply close the lid. That will give you the perfect placement and your dots will be all lined up!

Here it is….Please excuse the messy desk in the background.. I don’t pretend to be a neat crafter…

*

Here is the finished box.. Well, it is covered anyway. Now it is a free for some embellishing! I haven’t decided how to decorate mine yet. I will work on it when I have some time. Next week I will make cards to fit inside! Other ideas would be Cocoa or tea packets and a small mug… Cards on one side treats on the other… the options are endless. If you can get your hands on one of these boxes please show me what you came up with!

*I apologize for the crummy pictures. I need a big cardboard box so I can make a light box to take pictures of my finished projects! Have a great week!